{Water Methanon Injection Upgrade}
{A how to on installing a larger tank and the boost switchs for the injectors}
We started by using 1/8 inch by 1 inch wide by 4 foot aluminum flatbar
Read the text by placing mouse over the picture your viewing.   If alt text does not show up, especially if you're using Mozilla FireFox, then right click on the picture to read the alt text below properties. 
The first thing you need to do is bend up the flatbar to make an L-bracket
We took the old bottle and went with this 2.5 gallon unit in it's place.
   In the pictures below, you can get an ideo of how to mount the new water injection bottle to the back of the trunk cover.    You simply remove the cover, drill 4 holes, and mount the bottle as shown.
    We mounted ours to be centered with the trunk latch.
Top view of the bottle showing how we used the worm gear clamps to hold the bottle onto the flatbar.
Even though the flatbar flexes, the mounting is solid as can be. Flexibility is a must.
Here is the pump mounted on the passenger side of the rear of the trunk.
    Below is the how to on installing the boost switches for the injection system.   Since this particular brand has no way of really mounting, we found a way and thought we'd share our idea of how to do it.
Using a bench vice, bend your 90 degree bend as shown.
Here is what the L should look like and thei finished cut product.
Here's how the L bracket is going to be mounted via this hole. It's marked for drilling.
Stainless steel nut and bolt mounting the bracket to the switch.
This is how the unit will be mounted on the frame in the engine compartment.
Remove the headlight on drivers side and drill as shown.
5/16 nut and bolt, stainless were used for the mounting of the switches.
Here are the switches mounted to the frame. They're offset for easy tuning of the injectors of the water meth setup.
Full view of the switches and how easy they are to access.
Full wiring with all connections soldered for durability.